PM190 Water Methanol Injection Pump (50 GPH/3150CC PER MINUTE @ 190 PSI)

Description Pressure adjustable from 100-300 PSI 3/8 NPT female inlet & outlet port Motor turns 2200 RPM @ 12 volts 16.5 amperage draw Built-in bypass valve Built-in thermal protection Built-in anti reverse check valve Built-in heat sink on back of motor Heavy duty dual EPDM pump seals Pressure adjustable from 100-300 PSI Can run dry up to 1 hour without damage 100% methanol compatible Tested prior to shipping Made in the USA Weight 6.2lbs Flow & Horsepower Ratings @ 13.5 Volts: 1.7 gallons per minute open flow 190 liters per hour @ 180 PSI 50 gallons per hour @ 180 PSI 3150 cubic centimeters @ 180 PSI Supports up to 2500-4500 horsepower – 100% water mix Supports up to 1500-1900 horsepower – 50/50 water methanol mix Supports up to 1200-1600 horsepower – 100% methanol mix Special Notes: Do not use with petroleum products (E85, E98, gasoline, diesel, etc) Use 12 gauge wire for power and ground Does not include pump fittings. Pump fittings are available for sale separately Pumps come preset at 220 PSI – Expect 4-5 years of service if pump pressure is left at 220 PSI or below Running the pump over 250 PSI is not advised and will shorten pumps life All tests were performed using a 6AN stainless steel braided hose on the inlet side of pump Using 1/4″ outside diameter nylon on the inlet side of the pump will reduce pump performance and flow output Pump may be mounted vertical or horizontal Applications: Universal